Panasonic KX-NT400 Operating Instructions - Page 158
Start-up menu, Exiting the start-up settings, Setup, Language, IP Address, IP Port, Maintenance - firmware update
View all Panasonic KX-NT400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Installation and Settings Start-up menu From the menu on the Setup screen, you can access the following settings screens to configure the start-up settings: 1. Language (® Page 159) If your prefer to use a language other than English, change your language settings first. 2. IP Address (® Page 159) You must configure the IP address settings in order to connect to the network and use the KX-NT400. 3. IP Port (® Page 160) If your network uses different ports than the default settings, change these settings to match those of your network. For a list of defaults, see "Network- IP Port (Page 176)". 4. QoS (® Page 161) If your network uses QoS (Quality of Service) for voice communication, configure these settings to match those of your network. 5. Maintenance (® Page 162) View the MAC addresses for the KX-NT400's network adaptors, and test connections to other network devices. 6. Firmware Version Update (® Page 163) If a new firmware version is released, perform a firmware upgrade to install the latest version. For details about firmware, consult your dealer. 7. Initialize Settings (® Page 165) Initializing the settings resets the KX-NT400 to its factory shipment state. Performing this operation erases all data (contact lists, camera settings, etc.). 8. Firmware Version (® Page 165) View the installed version of various firmware components. 9. Error Log (® Page 166) View system error messages. Note • When you change certain settings, the KX-NT400 restarts automatically after you press Close on the Setup screen. For details, see "Restarting the KX-NT400 (Page 168)". Exiting the start-up settings 1. Press Close on the Setup screen. 158 Operating Instructions Document Version 2010-01