Sony XDSPD2000 User Manual (XDS-PD1000 and XDS-PD2000 Operation Manual for Fir - Page 57

Chapter 4 Recording, Playback and Copying Note Editing of the MPEG HD420 format is not supported. Editable video and audio signals This unit supports editing of the following signals on video and audio tracks. • Video - HD-SDI (for HD recording) - SD-SDI (for SD recording) • Audio - SDI - Analog - AES/EBU Notes • Editing cannot be done with a CIFS connection. • Recording of upconverted SD is not supported. Supported media Editing is possible on the internal storage only. Connections Make connections in the same way as for a cut editing system (see page 35). When making the connections, also refer to the operation manuals provided with the equipment to be connected. Preparations for editing Recording format settings Before performing clip editing, you need to set the recording format of the units to match the recording format of the editing target clip. The following table shows the required settings. Item Recording format Setting Check the recording format of the clip with the display window (see page 23) and select the same format with setup menu item 031 RECORDING FORMAT. Item Audio/Non-audio (data) Setting To perform insert editing of non-audio (data), set maintenance menu item M37: AUDIO CONFIG >M372: NONAUDIO INPUT to "data". Notes • When you insert non-audio into a clip, the channels containing the nonaudio are treated as non-audio across their entire length. • Use channel pairs (CH1/2, CH3/4, CH5/6, CH7/8) for non-audio insert editing. Non-audio editing is not executed unless a channel pair is specified. See page 103 for more information about setup menu operations. See page 126 for more information about maintenance menu operations. Settings required for editing The following table shows the settings required for editing. Item Setting Video input signal Select the video input signal with V INPUT on page P1 INPUT of the function menu. Audio input signal Select the audio input signal with A1 INPUT to A4 INPUT on the P1 INPUT page and with A5 INPUT to A8 INPUT on the P2 INPUT page of the function menu. Input audio level Adjust the input audio level with the CH-1/ALL CH and CH-2 to CH-4 knobs. Edit point transition With setup menu item 317 AUDIO type EDIT MODE, select "cut edit" or "cross fade". Time code • With TCG on page P4 TC of the function menu, select "INT". • With PRST/RGN on page P4 TC of the function menu, select "PRESET". • With RUN MODE on page P4 TC of the function menu, select "FREE RUN". Repeat playback mode With setup menu item 142 REPEAT MODE, select "off". See page 126 for more information about maintenance menu operations. See page 45 for more information about function menu operations. See page 103 for more information about setup menu operations. 57 Linear Editing