Kyocera ECOSYS FS-C8650DN FS-C8650DN Operation Guide - Page 33
Printing a Status Entering the Default Gateway
View all Kyocera ECOSYS FS-C8650DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Preparation before Use Entering the Default Gateway When DHCP is set to Off, enter the Default Gateway manually. 23 Press U or V to select Default Gateway. Default Gateway: a b 24 Press [OK]. The Default Gateway screen appears. /**0. 0. 0. 0 25 Use the numeric keys to set the default gateway. You can set any value between 000 and 255. The method for entering is the same as for the IP Address. 26 Press [OK]. The default gateway is stored and the IPv4 Setting menu reappears. This completes the network settings. Press [Menu] and end the Mode Selection Menu. Note When the network settings have been changed, the machine must be switched OFF then back ON again to make the changes effective. Printing a Status Page After completing the network settings, print a status page. The status page allows you to confirm a range of information, including network addresses and network protocols. To print a status page, select Status Page from the Report Print menu. Refer to Report Print on page 6-2 for detailed information. 2-7