Sharp MX-6201N MX-6201N MX-7001N Operation Manual Suite - Page 46

PLACING THE ORIGINAL ON THE DOCUMENT GLASS This section explains how to place the original on the document glass. Allowed original sizes Maximum original size Standard sizes 11" (height) x 17" (width) A3: 297 mm (height) x 420 mm (width) Non-standard sizes 297 mm (height) x 432 mm (width) When a non-standard size original is placed in copy mode, see "SPECIFYING THE ORIGINAL SIZE" in the Copier Guide. When a non-standard size original is placed for fax or scanner transmission, see "IMAGE SETTINGS" in the Facsimile Guide or Scanner Guide. Open the automatic document feeder. 1 Original size detector Place the original. Place the original face down in the far left corner of the document glass. Document glass scale mark Document glass scale mark 5-1/2" x 8-1/2" (A5) B5R 8-1/2" x 11"R (A4R) B5 8-1/2" x 14" (B4) 2 8-1/2" x 11" (A4) 11" x 17" (A3) The original should always be placed in the far left corner, regardless of its size. Align the top left corner of the original with the tip of the mark. Do not place any objects under the original size detector. Closing the automatic document feeder with an object underneath may damage the original size detector and prevent correct detection of the original size. If you are placing a small non-standard size original on the document glass, it is convenient to place a blank sheet of 8-1/2" x 11" or 5-1/2" x 8-1/2" (A4 or B5) paper on top of the original to facilitate detection of the original size. Close the automatic document feeder. After placing the original, be sure to close the automatic document feeder. If left open, parts outside of the original will 3 be copied black, causing excessive use of toner. 46