Sharp MX-6201N MX-6201N MX-7001N Operation Manual Suite - Page 667

Disabling of Devices Use these settings when a peripheral device on the machine has failed or when you wish to temporarily disable a device. Disabling of Document Feeder Use this setting to prohibit the use of the automatic document feeder, such as when the feeder malfunctions. (When the setting is enabled, scanning is still possible using the document glass.) Disabling of Duplex This is used to disable two-sided printing, such as when the duplex module malfunctions. Disabling of Large Capacity Cassette (When a large capacity tray is installed.) This setting is used to prohibit the use of the large capacity tray, such as when it malfunctions. Disabling of Tray Setting This setting is used to prohibit tray settings (except for the bypass tray). Disabling of Finisher (When a saddle stitch finisher or finisher is installed.) This setting is used to disable the saddle stitch finisher or finisher, such as when the unit malfunctions. Disabling of Inserter (When an inserter is installed.) This setting is used to prohibit the use of the inserter, such as when it malfunctions. Disabling of Offset (When a saddle stitch finisher or finisher is installed.) This setting is used to disable the offset function. Disabling of Stapler (When a saddle stitch finisher or finisher is installed.) This setting is used to prohibit stapling, such as when the stapler unit of the finisher or the saddle stitch finisher malfunctions. Disabling of Punch (When a punch module is installed.) This setting is used to prohibit punching, such as when the punch module of the finisher or the saddle stitch finisher malfunctions. Disabling of Color Mode (When a color-related problem has occurred.) When a color-related problem has occurred and printing is not possible, the use of color mode can be temporarily prohibited. Black & white printing will still be allowed. This function is only for use as an emergency measure. Once this setting is enabled, only a service technician can cancel the setting. Promptly contact your dealer or nearest SHARP service department to have a service technician cancel the setting and resolve the color-related problem. Fusing Control Settings This is used to set the weight of paper from 16 to 28 lbs. (60 to 105 g/m2) for control of fusing temperature by paper weight. To make this setting take effect, press the [POWER] key ( [POWER] key ( ) again to turn the power on. ) to turn the power off, wait briefly, and then press the 64