Sharp MX-6201N MX-6201N MX-7001N Operation Manual Suite - Page 60

MANUALLY OPERATING THE INSERTER The inserter can be used for stapling or punching without performing a copy operation. These functions are selected at the operation panel of the inserter. (1) (2) (3) (1) [PUNCH] key ( ) When a punch module is installed on the finisher or saddle stitch finisher, punch holes can be added to blank paper or printed paper. The indicator lights when this function is selected. (2) [STAPLE] key ( ) / indicator When this function is selected, each set of output is stapled and delivered to the finisher or saddle stitch finisher tray. (Note that the sets are not offset.) Press this key until the icon indicator of the desired staple position lights up. ( (pamphlet stapling) can only be selected when a saddle stitch finisher is installed.) (3) [START] key ( ) / indicator After selecting punch or staple settings with the key of (1) or (2), place the paper to be punched or stapled on the paper tray of the inserter and press this key. • Do not use tab paper when operating the inserter manually. • The punch and staple functions cannot be used when a malfunction has occurred in the finisher or saddle stitch finisher, or the inserter, finisher, saddle stitch finisher, or punch module has been disabled in the system settings (administrator). Paper guide 7 1 8 Load paper in the inserter. Load the paper face up. When performing pamphlet stapling, place the paper so that the opened pages are face up as shown. Adjust the paper guide to the size of the paper. Press the desired output mode key. To perform stapling or pamphlet stapling, touch the [STAPLE] key ( ). To perform punching, touch the [PUNCH] key ( ). The indicator of the selected mode lights up. 2 Pamphlet stapling can only be used when the saddle stitch finisher is installed. Stapling and punching cannot be used in combination with pamphlet stapling. 60