Yamaha AW2400 Owner's Manual - Page 114

Using external effects with the AUX buses ● Signal Flow When Using an External Effect Processor Track 1 Track 2 Track 3 Track 4 Track 5 Effect Processor [OMNI OUT] jack 1 [MIC/LINE INPUT] jacks 3/4 Track channels AUX Bus master channel Input channels Stereo output channel 13 x Number of play tracks x Number of play tracks AUX bus 1 Stereo bus AUX 9 Press the Selected Channel section [PAN/ EQ] key so that its indicator lights, then press Selected Channel knob 1 as many times as necessary to display the PAN/EQ screen Input/RTN page. 10 Set the input channel 3 and 4 pan controls fully left and right, respectively. This ensures full stereo effect from the stereo effect processor. You could also pair inputs 3 and 4 for easy stereo control. Mixer section 11 Raise the [STEREO] fader to the 0-dB level and, while playing back the song, adjust the input level of the external effect processor as well as the input levels of input channels 3 and 4 using the [GAIN] knobs. If necessary return to step 7 and readjust the send levels from the track channels to the AUX1 bus as required. You can also adjust the AUX1 bus master level by selecting the appropriate layer and fader via the Layer section [MASTER] key and channel [SEL] key, or by using the CH VIEW screen View page LVL knob. NOTE • With this setup be sure to set all AUX send levels for input channels 3 and 4 to - ∞ to prevent feedback. 12 Turn the RECORD screen Mixdown page REC button on and begin the actual mixdown process. 114 AW2400 Owner's Manual