Yamaha AW2400 Owner's Manual - Page 12
About the built-in CD-RW drive, Using the CD-RW drive - case
View all Yamaha AW2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
About the built-in CD-RW drive • Using the CD-RW drive About the built-in CD-RW drive 1 A built-in CD-RW drive is a device that lets you create or play audio CDs, backup and restore data from the internal ■ Handling hard disk, and read data from a CD-ROM. 1 Never touch the objective lens. Before you start IMPORTANT • Even if a CD-RW drive is operating normally, it may fail a read or write operation approximately once in five hundred times. • Yamaha will take no responsibility for any damages, direct or consequential, that may result from the use of the above CDRW drive. B Be careful that the objective lens does not become dusty or dirty. C If the objective lens becomes dusty, use a commercially available blower etc. to blow the dust off with clean air. D Since the inside of the drive contains powerful magnetic circuitry, do not allow any magnetic material to come near the drive. (In particular, any metallic fragments, screws, or pins that enter the drive mechanism will cause operation to fail.) Using the CD-RW drive To insert a disc into the CD-RW drive, press the eject switch. The disc tray will open. Place the disc on the tray, and gently push the disc tray in. NOTE • The disc tray is ejected electrically. If the disc tray is not ejected when you press the eject switch, turn on the power of the AW2400 and press the eject switch once again. ■ Removing a CD in an emergency If you are unable to remove the disc by pressing the eject switch, insert a wire of less than 2 mm diameter (such as a straightened paper clip) into the eject hole, and push gently. However, pressing the eject switch will not eject the disc when the AW2400 is in the following states, so do not use this method in such cases. • When the AW2400's power is "OFF" • When the disc is being accessed (data is being read, written, or erased) • While in CD PLAY mode Eject hole Eject switch CAUTION • This removal method is for use in emergencies such as when you cannot remove the disc due to a malfunction of the disc tray or a power failure. Do not use this method unnecessarily, since doing so will damage the CD-RW drive. 12 AW2400 Owner's Manual