Yamaha AW2400 Owner's Manual - Page 89
Hold down the [SET] key and press the key, register as a locate point.
View all Yamaha AW2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Using the locator The procedure for registering the current location in one of the locate points, and then moving to that locate point is as follows. 1 Move the song to the point that you want to register as a locate point. You can set locate points while the song is playing or stopped. 2 Hold down the [SET] key and press the key for the desired locate point. 3 To move to a registered locate point, press the corresponding key while the song is stopped or playing. The song will move to that location. Registered locate points are displayed in the TRACK screen Track View page as shown below. The locate points correspond to the following keys. E A B CD F Locator icons The characters/numbers shown on the display correspond to the locate types are as follows: Displayed Character/ Number Locate Type I In point O Out point 9 A A point B B point L1-L9 Quick Locator points S Start point E End point R Relative Zero point Transport/Locate Operation HINT • Locate point settings are stored on the hard disk as part of the song. • Locate points can be adjusted as desired (→ p. 91). Locate points other than the Start point and End point may also be erased (→ p. 93). 1 [IN] key In point B [OUT] key Out point C [A] key A point D [B] key B point E [LOCATE] key 1-9........ Quick Locator points F RTZ [ ] key Relative Zero point NOTE • The In point and Out point will be updated automatically when you perform a record operation. • If you want to change the Start point or End point, use the EDIT screen Mark Adj. page. These points cannot be set directly via the panel controls. AW2400 Owner's Manual 89