Yamaha AW2400 Owner's Manual - Page 120

Inserting an Effect Into a Channel 5 Use the [DATA/JOG] dial or [INC]/[DEC] keys to select the desired effect and/or I/O card channel, then press the [ENTER] key. When EFF1-4 is selected the corresponding effect will be inserted in the signal path. Insert points ■ Internal effect inserted pre-EQ (input channel) 6 To select the insert point move the cursor to the symbol below INSERT EFF on the display and press the [ENTER] key. Press [ENTER] repeatedly to sequentially select the pre-EQ → post-EQ pre-fader → post-fader insert points. When an effect and compressor are both inserted at the same point you can move the cursor directly to the insert point and press the [ENTER] key to swap the positions of the effect and compressor. The signal flow is as follows. ● INSERT EFF = EFF 1 Effect 1 PHASE GATE EQ ATT ON LVL ■ External effect inserted pre-EQ (input channel) When SLOT1-16 is selected an external effect processor 14 can be inserted into the channel via the selected I/O card channel. In this case the signal flow is as follows. Effects ● INSERT EFF = SLOT1 External effect processor Output channel = 1 Input channel = 1 I/O card PHASE GATE EQ ATT ON LVL 7 Call the EFFECT screen FX Edit page or FX Lib. page to adjust the internal effect mix balance (the balance between the effect and direct signals). 8 Use the MIX BALANCE field knob to balance the effect and direct sound as required. A setting of 0% produces only the direct sound while a setting of 100% produces only the effect sound. HINT • Refer to "Editing Effects" on page 121 for details on the EFFECT screen FX Edit page. 120 AW2400 Owner's Manual