Casio CFX-9800G-w Owners Manual - Page 191
■When, ■Replacing
UPC - 079767128685
View all Casio CFX-9800G-w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
Appendix A Power supply This unit is powered by two AAA-size (LR03 (AM4) or UM-4) batteries. In addition, it uses a single CR2032 lithium battery as a back up power supply for the memory. ■When to Replace Batteries If the following message appears on the display, immediately stop using the calculator and replace batteries. *'*Low battery Noll If you try to continue using the calculator, it will automatically switch power off, in order to protect memory contents. You will not be able to switch power back on until you replace batteries. Be sure to replace batteries at least once every two years, no matter how much you use the calculator during that time. Warning! • If you remove both the main power supply and the memory back up batteries at the same time, all memory contents will be erased. Be sure to read the following section before doing anything. The batteries that come installed in this unit when you purchase it are for factory test purposes, so they will probably not provide normal service life. ■Replacing Batteries Precautions: Incorrectly using batteries can cause them to burst or leak, possibly damaging the interior of the unit. Note the following precautions: •Be sure that the positive ®+ and negative 0 poles of each battery are facing in the proper directions. •Never mix batteries of different types. •Never mix old batteries and new ones. •Never leave dead batteries in the battery compartment. •Remove the batteries if you do not plan to use the unit for long periods. •Never try to recharge the batteries supplied with the unit. •Do not expose batteries to direct heat, let them become shorted, or try to take them apart. 0 (Should a battery leak, clean out the battery compartment of the unit immediately, taking care to avoid letting the battery fluid come into direct contact with your skin.) -346- Keep batteries out of the reach of small children. If swallowed, consult with a physician immediately. •To replace the main power supply batteries Important •Never remove the main power supply and the memory back up batteries from the unit at the same time: *Be sure to switch the unit off before replacing batteries. Replacing batteries with power on will cause data in memory to be deleted. *Never replace the mainpower supply battery compartmentcover or switch the calculator on while the main power supply batteries are removed from the calculator or not loaded correctly. Doing so can cause memory data to be deleted and malfunction of the calculator. If mishandling of batteries causes such problems, correctly load batteries and then perform the RESET operation (page 349) to resume normal operation. *Be sure to replace all two batteries with new ones. ®Switch the power of the calculator off, and slide the calculator into its hard case. ®Remove screw ®on the back of the calculator, and remove the main battery compartment cover. @Remove the two old batteries. e ®Load a new set of two batteries, making surethat' their Positive C) and negative ends'are facing in the proper directions. C)Insert the tabs of the main battery compartment cover into the slots inthe back of the calculator and replace the cover. Secure it in place with the screw. •Power will not switch on if you press Mg while the main power supply battery compartment cover is open. screw @Remove the calculator from its hard case and press CE to switch power on. •Power supplied by memory back-up batteries while the main power supply batteries are removed retains memory contents. •Do not leave the unit without main power supply batteries loaded for long periods. Doing so can cause deletion of data stored in memory. -347-