HP 9500hdn HP Color LaserJet 9500n/9500hdn - User Reference Guide - Page 29
Step 12. Install the four image drums, To install the image drums - printer cartridges
UPC - 808736429689
View all HP 9500hdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Step 12. Install the four image drums 1 The printer uses four image drums: yellow, magenta, cyan, and black. Use the following procedure to install the image drums. In this example, the yellow drum is being installed. The drums can be installed in any sequence, but each drum must be installed in the correct slot for that color. To install the image drums 1 Swing the large, green lever down. 2 2 Rotate the blue dial up until it clicks and the image drum door unlatches. 3 Open the image drum door completely. Remove any styrofoam packing material that you find inside. 4 Remove the yellow drum from its packaging. CAUTION 3 Do not remove the protective cover on the underside of the drum until step 7. Do not touch the green component inside the drum cartridge. CAUTION If toner gets on your clothes or hands, wash them in cold water. Hot water causes toner to adhere to fabric. 4 5 Place the drum on a level surface. Pull the orange ring on the end of the drum all the way out to remove the seal from inside the drum. Pull the orange handle on the top of the drum to remove the protective sheet, the silica gel pack, and the orange tape and discard them. Pull the two orange rings on the side of the drum to remove them. 5 Note Do not shake the drum. 1 Printer setup 27