HP Designjet 2800/3800cp Service Manual - Page 106
If This Test Passes, Do Not Replace Any Of The Sensors.
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
D08. Sensors The purpose of this test is to verify the operation of the following Sensors: D Window Sensor. D Right Door Sensor. D Left Door Sensor. D Refill Valve Sensors. D Standby Button Sensor. D Media Sensor. D Pincharm Sensor. IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE REPLACING ANY OF THE SENSORS. IF THIS TEST PASSES, DO NOT REPLACE ANY OF THE SENSORS. Perform the Sensors test as follows: 1 In the Diagnostics submenu, scroll to "D08 Sensors" and press Enter. Diagnostics D08 Sensors 2 Follow the instructions on the front-panel display. If you do not complete each step within 10 seconds, the "08XX Fail" message is displayed on the front-panel. The XX corresponds to the sensor which you were testing. 3 If you follow all the instructions and the test passes, the "0800 OK" message is displayed on the front-panel. IF THIS TEST PASSES, DO NOT REPLACE ANY OF THE SENSORS. 4 If the test fails, an error message will be displayed on the front-panel. The error messages are split into different areas depending on which component failed. Cover Sensor Failure If there is a problem with the Cover Sensor then the following message will appear: D "D0801 Fail" - Window Sensor failed. The test is continued on the next page. 4-20 HP DesignJet CP Series Printers Service Tests