HP Designjet 2800/3800cp Service Manual - Page 291
Installation of the drive roller, Installation of the overdrive assembly
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 291 highlights
Installation of the drive roller Note: Make sure all the pincharm assemblies (item 11) are in the correct position before performing the next step. 1. Install the drive roller (item 10). Make sure the bearings at either end of the drive roller are installed into the correct position in the left and right hand side chassis. 2. Install the shoulder screw (item 6) securing the cluster gear (item 7) to the chassis. 3. Install the following: 1. Service Station Assembly ' page 8-26. 2. X-Axis Motor Assembly ' page 8-45. Installation of the overdrive assembly 4. Install the overdrive assembly (item 9) by holding both ends and sliding the left end first through a sleeve bearing (item 12) into the mount block (item 13). 5. Install two T-10 screws (item 8) securing the overdrive assembly to the left and right hand side chassis. 6. Install the clutch (item 4) and two washers (item 5) on the left end of the overdrive shaft, then secure with the retaining clip (item 3). 7. While pressing down on the roller support bracket, install two T-15 screws (item 1) securing the roller support bracket to the chassis. 8. Install the top half of the elevator assembly by securing it to two retaining clips at the back and push down and to the right. 9. Install the following: 1. Cutter Assembly ' page 8-48 2. Bail Arm Assembly ' page 8-58 3. Right Hand Cover ' page 8-21. 4. Left Hand Cover ' page 8-18. 5. Window and Top Cover ' page 8-15. 10. Connect the power cord and turn the printer on in service mode. 11. Perform following calibrations: 1. C08 Service Accuracy Calibration ' page 5-17. 12. Perform following service tests: 1. D11 Bail Service Test ' page 5-12 2. D05 Service Station Service Test ' page 4-16 8-70 HP DesignJet CP Series Printers Removal and Installation