HP Designjet 2800/3800cp Service Manual - Page 231

Additional Rear Cover (Only applicable to HP DesignJets 3500CP and 3000CP) Refer to figure 1B ' page 8-11 Removal 1. Remove the central and right hand back covers (items 1 and 2) by releasing them from holding clips. 2. Remove the eight T-20 screws (item 3) which secure the top cover to the electronics module. 3. Remove the four T-20 screws (item 4) which secure the additional rear cover (item 5) to the cover support structure (item 6). 4. Remove the additional rear cover (item 5) from the cover support structure (item 6). Installation Note: Working from the rear of the printer. 1. Install the additional rear cover (item 5) onto the cover support structure (item 6). 2. Install the four T-20 screws (item 4) which secure the additional rear cover (item 5) to the cover support structure (item 6). 3. Install the eight T-20 screws (item 3) which secure the top cover to the electronics module. 4. Install the central and right hand back covers (items 1 and 2). 8-10 HP DesignJet CP Series Printers Removal and Installation