HP Designjet 2800/3800cp Service Manual - Page 308
Interconnect Cables, Note: Working from the rear of the printer.
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
Interconnect Cables Refer to figure 29 ' page 8-89 WARNING Switch off the printer and remove the power cord. Removal of the refill interconnect cable. 1. To remove the following: 1. Electronics Module ' page 8-6. 2. Left Hand Cover ' page 8-18. 3. Right Hand Cover ' page 8-21. 2. Remove the top half of the elevator assembly by releasing it from two retaining clips at the back and lifting up and to the left. 3. Carefully disconnect the refill interconnect cable from position J1 on the refill interconnect PCA. Note: Working from the rear of the printer. 4. Remove the refill interconnect cable from the cable clamp on the right hand side chassis. 5. Pull the refill interconnect cable through the hole (item 1) in the right hand side chassis. 6. Remove the refill interconnect cable from five cable clamps (item 2) located at the back of the printer. 7. Remove the two T-20 screws (item 3) securing the ferrite clamp (item 4) to the left hand side chassis. 8. Remove the refill interconnect cable and the ferrite (item 5) from the ferrite clamp. Removal of the service station interconnect cable. 1. Remove the following: Note: Working from the rear of the printer. 1. Right Hand Cover ' page 8-21. 2. Remove the left hand back cover by releasing it from the holding clips. 3. Carefully disconnect the service station interconnect cable from the electronics module from position J11 SRVCE STN. 4. Carefully disconnect the service station interconnect cable from the service station interconnect PCA located underneath the service station assembly. Removal and Installation HP DesignJet CP Series Printers 8-87