HP Designjet 2800/3800cp Service Manual - Page 70

User Messages for HP DesignJets 2500CP and 2000CP with Firmware Version A.02.14 or Higher and HP DesignJets 3500CP and 3000CP NOTE FOR HP DESIGNJETS 2500CP AND 2000CP: IF YOU HAVE ANY USER MESSAGES WHICH ARE NOT LISTED IN THIS CHAPTER, THEN CHECK WHICH FIRMWARE VERSION IS INSTALLED IN THE PRINTER, AND IF NECESSARY UPGRADE TO FIRMWARE VERSION A.02.14 OR HIGHER. This is a list of the messages in the front-panel display. If an action is needed, it is shown in italics in the Explanation and Action column. The messages are listed in alphabetical order, except that the STATUS messages follow all other messages. Message Explanations and Actions Message Explanation and Action Accessing head cleaners Accessing printheads Action unavailable Entry being printed The printer is moving the platform that contains the printhead cleaners to a place where you can access them. Wait for a few seconds until this operation has finished. The printer is moving the carriage that contains the printheads to a place where you can access them. Wait for a few seconds until this operation has finished. A print is being printed and you have requested to move, delete or modify the number of copies through the queue management menu. You cannot change the current entry until the print has finished. Wait until the print has finished. Calibrate error Continue → Calibrate Yes → Color Νο → The calibration print was loaded incorrectly and it could not be measured. Press ↓ to continue, then reload the print for measurement. Follow front panel instructions. You are using sheet media and color calibration is on. The printer is asking you if you want to calibrate the color for the loaded media. Press ↑ for yes. Press ↓ for no. 3-2 HP DesignJet CP Series Printers User Messages