HP Designjet 2800/3800cp Service Manual - Page 135
C06. Printheads Check, Enter, C0603 Fail - The Cyan and Magenta Printheads have failed.
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
C06. Printheads Check The purpose of this calibration is to check that the Nozzles of the Printheads are functioning correctly. Perform the Printheads Check calibration whenever: D Carriage is disassembled or replaced. D Banding is detected in prints. D Nozzles Out or Misdirected. D Misalignment between colors is detected. D Electronics Module is replaced. Load media before performing this test. Perform the Printheads Check Calibration as follows: MAKE SURE THAT THE WINDOW IS CLOSED BEFORE YOU PERFORM THIS CALIBRATION. 1 In the Calibrations submenu, scroll to "C6 Printheads Check" and press Enter. Calibrations C6 Printheads Check 2 If media is not loaded the calibration will stop and the message "Load Media to Check Printheads" will be displayed on the front-panel. Load media in order to continue the calibration. 3 While the Calibration is being performed, the message "Checking Printheads" will be displayed on the front-panel. 4 If the calibration is performed correctly, the "C0600 Done" message is displayed on the front-panel. 5 If the calibration fails, one of the following messages will be displayed on the front-panel: D "C0601 Fail" - The Cyan Printhead has failed. D "C0602 Fail" - The Magenta Printhead has failed. D "C0603 Fail" - The Cyan and Magenta Printheads have failed. D "C0604 Fail" - The Yellow Printhead has failed. D "C0605 Fail" - The Cyan and Yellow Printheads have failed. The calibration is continued on the next page. 5-14 HP DesignJet CP Series Printers Service Calibrations