HP Designjet 2800/3800cp Service Manual - Page 269
Cutter Assembly Only Applicable to, HP DesignJets 2500CP and 2000CP
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
Cutter Assembly (Only Applicable to HP DesignJets 2500CP and 2000CP) Refer to figure 17A ' page 8-49 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Right Hand Cover ' page 8-21. 2. Remove the window. 3. Move the Carriage Assembly to the right. 4. Remove the stopper (item 1) located on the right end of the overdrive assembly. 5. Remove the cutter assembly (item 2) from the slider rod by sliding it to the left and pulling it off the rear bushing (item 3). Installation Note: Make sure you install the front wheel of the media cutter under the lip of the starguard assembly. 1. Install the cutter assembly (item 2) onto the rear bushing (item 3) and slide to the left. To obtain the correct position so that the cutter assembly moves easily into position, you may have to move the cutter wheel (item 4) (which is sprung loaded). 2. Install the stopper (item 1) located on the right end of the overdrive assembly onto the overdrive assembly. 3. Install the following: 2. Right Hand Cover ' page 8-21. 4. Install the window. 5. Install the power cable and turn the printer on in service mode. 6. Perform D10 Cutter Service Test ' page 4-24 8-48 HP DesignJet CP Series Printers Removal and Installation