HP Designjet 2800/3800cp Service Manual - Page 251
Right Hand Cover, Window and Top Cover, Holding the retaining clip up
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
Installation 1. Install the primer assembly (item 3) into the correct position in the service station assembly (item 4), making sure no cables are trapped between the two assemblies. 2. Install three T-15 screws (item 2) securing the primer to the service station assembly. 3. Connect the primer sensor cable to the position J4 on the service station interconnect PCA. 4. Connect the primer stepper cable to the position J8 to the service station interconnect PCA. 5. Route the cables through the cable clamps on the underside of the service station assembly. 6. Holding the retaining clip up, slide the service station interconnect PCA into place underneath the service station assembly. 7. Connect the 4 tubes (item 1) to the primer assembly, making sure that the tubes are correctly connected to the corresponding colour on the head cleaner. 8. Install the following: 1. Right Hand Cover ' page 8-21. 2. Window and Top Cover ' page 8-15. 9. Install the power cable. 8-30 HP DesignJet CP Series Printers Removal and Installation