HP Designjet 2800/3800cp Service Manual - Page 274

Installation Note: At the same time as performing step one, install loose cables into the cable clamp, which is located on the left hand side chassis. 1. Install the elevator assembly onto the three loosened T-20 screws (item 2). Tighten the three screws. 2. Install the T-20 screw (item 1) into the bottom rear of the elevator assembly. 3. Connect the platform sensor cable in position J5 PLATEF SENSOR on the refill interconnect PCA. 4. Connect the elevator stepper motor cable in position J9 ELEV STEPPER on the refill interconnect PCA. 5. Install the top half of the elevator assembly by securing it to two retaining clips at the back and push down and to the right. 6. Install the following: 1. Left Hand Cover ' page 8-18. 2. Window and Top Cover ' page 8-15. 7. Install the ink delivery system (Refer to the User Guide). 8. Install the power cable and turn the printer on in service mode. 9. Perform D06 Refill Service Test ' page 4-18 Removal and Installation HP DesignJet CP Series Printers 8-53