HP Designjet 2800/3800cp Service Manual - Page 49
Switch the Printer OFF and ON again. During
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
System Error: 010039 Problem Description: A Printhead voltage could not be set - Carriage PCA Failure Corrective Action: Try the following: D Make sure that the Trailing Cable is connected correctly. D Replace the Trailing Cable ' page 8-36. D Replace the Carriage Assembly ' page 8-42. Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. System Error: 010040 Problem Description: The Ambient Temperature measured is out of the normal range. Corrective Action: Try the following: D Make sure that the Trailing Cable is connected correctly. D Replace the Trailing Cable ' page 8-36. D Replace the Carriage Assembly ' page 8-42. D Replace the Electronics Module ' page 8-6. Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. System Error: 010041 Problem Description: Problem in setting the Printhead Voltage. Corrective Action: Switch the Printer OFF and ON again. During initialization another error code will appear. Refer to the relevant error code for further information. 2-14 HP DesignJet CP Series Printers System Error Codes