HP Designjet 2800/3800cp Service Manual - Page 80

Message Printhead removed JJ-J→ Printing disabled→ Pull ↓ Align ↔ edges to roll Reload media Reload sheet Remove all ink cartridge(s) Remove all printheads Remove head cleaners Close right door Remove media Remove media Lift lever Explanation and Action The printer has detected that one or more printheads have become dislodged or the printer cannot detect them, as indicated by the flashing squares. Press ↓ to continue. You should reseat the printheads immediately or replace the ink system. If you don't correct the error now, you will see the status message "Ink system error". The printer cannot print, because of errors previously notified. Press ↓ to continue. Then press the Replace Ink System key to replace the erroneous ink systems in order to print with your printer again. You are aligning roll media. Grasp the left and right free edges of the roll media and pull them towards you until the media is taut. At the same time, align the left and right edges of the media so that they are flush with the left and right edges of the roll. There was an error loading the media and the printer has ejected it. The printer is waiting for you to reload the media. Reload the media. Sheet media was loaded skewed and the printer ejected it. Reload the sheet. You have selected the option Utilities / Transport mode of the front-panel menu, and opened the left door when instructed. The printer is instructing you to remove all the ink cartridges. You have selected the option Utilities / Transport mode of the front-panel menu, and lifted the window when instructed. The printer is instructing you to remove all the printheads. You have selected the option Utilities / Transport mode of the front-panel menu, and opened the right door when instructed. The printer is instructing you to remove all the printhead cleaners, and then close the right door. The ink is dry. Remove the accuracy calibration print that has just been produced. Press ↓ to continue with accuracy calibration. An attempt to load media was made while the media lever was lowered. Remove the media, lift the lever, and reload media with the lever up. 3-12 HP DesignJet CP Series Printers User Messages