HP Designjet 2800/3800cp Service Manual - Page 300

Installation 1. Carefully push the media sensor assembly (item 1) onto the retaining pin located underneath the entry platen. WARNING Care should be taken while performing the following procedure, the entry platen has sharp edges and could cause injury. Note: On the inside of the left and right hand side chassis, there are locating pins (item 4). The correct locating pin for the entry platen is located just below the starguard assembly. 2. Install the entry platen (item 2) onto the entry platen locating pins (item 4). Caution: Be careful not to drop the entry platen. Support the entry platen throughout the next step. 3. Install two T-15 screws (item 5) into the right hand side chassis securing the entry platen. 4. Install two T-15 screws (item 3) securing the entry platen to the left hand side of chassis. 5. Install the top half of the elevator assembly by securing it with two retaining clips at the back and push down and to the right. 6. Connect the media sensor cable to the electronics module in position J6 MEDIA. 7. Install the media sensor cable in the cable clamp at the rear of the printer. 8. Install the following: 1. Right Hand Cover ' page 8-21. 2. Left Hand Cover ' page 8-18. 3. Window and Top Cover ' page 8-15. 9. Connect the power cord and turn the printer on in service mode. 10. Perform D08 Sensor Service Test ' page 4-31 Removal and Installation HP DesignJet CP Series Printers 8-79