HP Designjet 2800/3800cp Service Manual - Page 331
Connect to the network, Appendix-4
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 331 highlights
Connect to the network The network ports on the motherboard are: • AUI (Attachment Unit Interface) port for a thin Ethernet cable (thinnet) or a thick Ethernet cable (thicknet) • RJ-45 port for 10/100BaseT twisted pair TO CONNECT A THINNET OR THICKNET CABLE TO THE FIERY X2-W: 1. Power off the Fiery X2-W before connecting it to any network device. 2. With the AUI slide latch in the open position, connect the network cable to the AUI port on the back of the Fiery X2-W (see h in illustration of back panel on page 1). Slide the latch to lock the connector in place. • To connect a 10Base2 thinnet cable to the Fiery X2-W, an Ethernet transceiver must be installed on the Fiery X2-W AUI port. The thinnet cable then connects to the BNC connector on the Ethernet transceiver. If the transceiver has an SQE switch, make sure the switch is set to OFF. • To connect a 10Base5 thicknet cable to the Fiery X2-W, connect the AUI drop cable directly to the AUI port on the back of the Fiery X2-W. 3. Work with the system administrator at the customer site to configure Setup options. Use the Configuration page from the deinstalled Fiery X2-W as a guide. (Network setup is detailed in the Administrator Guide that came with the user documentation.) 4. Verify the network connection and perform any additional network Setup required. Print a Configuration page from the Print Pages submenu (see page 2) for reference. 5. Verify that the Fiery X2-W appears in the list of printers on a networked computer, and print a few test documents from a computer that will use the Fiery X2-W. TO CONNECT A TWISTED PAIR CABLE TO THE FIERY X2-W: 1. Power off the Fiery X2-W before connecting it to any network device. 2. Connect the network cable to the RJ-45 port on the back of the Fiery X2-W (see i in illustration of back panel on page 1). A Category 5 unshielded twisted pair (UTP) network cable must be used for 100BaseT. 3. Work with the system administrator at the customer site to configure Setup options. Use the Configuration page from the deinstalled Fiery X2-W as a guide. (Network setup is detailed in the Administrator Guide that came with the user documentation.) HP DesignJet CP Series Printers Appendix-4