HP Designjet 2800/3800cp Service Manual - Page 234
Installation, J15 HDD PWR, J22 Hard Disk Drive, Perform the C10 Font Type Set calibration, 20 Only
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 234 highlights
Installation 1. Pull the power switch cable through the hole in the electronics module, then push the rocker switch (item 11) into the hole securing it with retaining clips. 2. Connect the power switch cable (item 10) to position J2 on the power PCA. 3. Connect the hard disk power cable (item 8) to position J15 HDD PWR on the main PCA. 4. Connect the hard disk power cable (item 7) to the hard disk driver. 5. Connect the data cable (item 6) to position J22 Hard Disk Drive on the main PCA 6. Connect the data cable (item 5) to the hard disk drive. 7. Install the black polystyrene hard disk holder (item 3) with the hard disk drive (item 4) inside into the correct position in the electronics module. 8. Install eight screws (item 1) into the electronics cover (item 2) securing it to the electronics module. Be careful not to damage the sheet metal MIO gasket which surrounds the centronics port. 9. Connect the power cord and turn the printer on in service mode. 10. Perform the C10 Font Type Set calibration ' page 5-20 (Only for Asian Fonts). 11. Perform the D01 Electronics service test ' page 4-7. Removal and Installation HP DesignJet CP Series Printers 8-13