HP Designjet 2800/3800cp Service Manual - Page 242
Right Hand Cover and Right Hand Trim Assembly, Switch off the printer and remove the power cable.
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
Right Hand Cover and Right Hand Trim Assembly Refer to figure 6 ' page 8-23 Removal 1. Remove the ink delivery system (Refer to the User Guide). WARNING Switch off the printer and remove the power cable. 2. Remove the left hand back cover. 3. Disconnect the front panel cable from position J1 FRONT PANEL on the electronics module. 4. Disconnect the stand-by button cable from position J2 ON/STBY on the electronics module. 5. Remove the following: 1. Window and Top Cover ' page 8-15. 6. Open the door on the right hand cover (item 1). Note: Position the pinch-arm lever at half way to enable you to perform the next step (item 2). 7. Remove the right hand trim assembly (item 3) by removing five T-15 screws (item 4) and disconnecting two cover sensors (item 5) located on the inside. Be careful not to drop the cover (item 7) once the securing fasteners have been removed. Support the cover throughout the next step. The right hand cover and window sensors can be removed by disconnecting them from the front panel assembly. 8. Remove the three T-15 screws (item 6) securing the right hand cover to the right hand side chassis. 9. Remove the right hand cover (item 7), carefully passing the front panel cable and the stand-by button cable through the hole in the right hand side chassis. Removal and Installation HP DesignJet CP Series Printers 8-21