HP Designjet 2800/3800cp Service Manual - Page 290
Overdrive Assembly and Drive Roller Only, Applicable to HP DesignJets 2500CP and 2000CP
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
Overdrive Assembly and Drive Roller (Only Applicable to HP DesignJets 2500CP and 2000CP) Refer to figure 25A ' page 8-71 WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Window and Top Cover ' page 8-15. 2. Left Hand Cover ' page 8-18. 3. Right Hand Cover ' page 8-21. 4. Bail Arm Assembly ' page 8-58 5. Cutter Assembly ' page 8-48 2. Manually slide the carriage assembly to the right side of the printer. 3. Remove the top half of the elevator assembly by releasing it from two retaining clips at the back, then lifting up and to the left. 4. Remove the two T-15 screws (item 1) securing the roller support bracket (item 2) to the left hand side chassis. 5. Remove the roller support bracket. 6. Remove the clutch (item 4) and washers (item 5) on the left end of the overdrive shaft by removing the retaining clip (item 3). 7. Remove the two T-10 screws (item 8) securing the overdrive assembly (item 9) to the left and right hand side chassis. 8. Remove overdrive assembly by lifting it out on the right, then sliding to the right. To remove the Drive Roller only 9. Remove the following: 1. X-Axis Motor Assembly ' page 8-45. 2. Service Station Assembly ' page 8-26. 10. Remove the shoulder screw (item 6) securing the cluster gear (item 7) to the left hand side chassis. 11. Move the pinch-arm lever to the up position. 12. Remove the drive roller (item 10) by holding the ends and lifting out. Removal and Installation HP DesignJet CP Series Printers 8-69