HP Designjet 2800/3800cp Service Manual - Page 263
Switch off the printer and remove the power cord.
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 263 highlights
Carriage Assembly Refer to figure 14 ' page 8-44 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Left Hand Cover ' page 8-18. 2. Window and Top Cover ' page 8-15. 3. Right Hand Cover ' page 8-21. 4. Service Station Flag ' page 8-26 5. Encoder Strip ' page 8-32. 6. Y-Axis Belt ' page 8-39. 2. Carefully disconnect the trailing cable from the carriage assembly. 3. Remove the trailing cable carriage clamp (item 1) from the carriage by releasing it from the retaining clips. 4. Remove the Y-axis tensioner holder by removing two T-20 screws from the slider rods. Caution: The rear bushing (item 2) on the carriage assembly is tensioned with a spring (item 3). When removing the carriage assembly, hold the rear bushing on the carriage assembly. 5. Remove the carriage assembly (item 4) by sliding it off the slider rods. 6. Remove the Y-axis belt (item 5) from underneath the carriage assembly. 8-42 HP DesignJet CP Series Printers Removal and Installation