HP Designjet 2800/3800cp Service Manual - Page 233

Hard Disk Drive, Power Switch Cable THE HARD DISK DRIVE IS ONLY APPLICABLE FOR THE HP DESIGNJET 2500CP/3500CP PRINTER. Refer to figure 2 ' page 8-14 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Window and Top Cover ' page 8-15. 2. Remove the electronics cover (item 2) by removing eight screws (item 1) securing it to the electronics module. 3. Remove the black polystyrene hard disk holder (item 3) with the hard disk drive (item 4) inside. 4. Disconnect the data cable (item 5) from the hard disk drive 5. Disconnect the data cable from position J22 Hard Disk Drive from the main PCA (item 6). 6. Disconnect the hard disk power cable (item 7) from the hard disk driver. 7. Disconnect the hard disk power cable from position J15 HDD PWR from the main PCA (item 8). 8. Lift up the black plastic guard (item 9) on the power PCA and disconnect the power switch cable (item 10) from position J2 on the power PCA. 9. Remove the power switch cable by pinching together the retaining clips on the rocker switch (item 11), then pulling the switch and the cable through the hole in the electronics module. 8-12 HP DesignJet CP Series Printers Removal and Installation