HP Designjet 2800/3800cp Service Manual - Page 248
Installation of the Service Station Assembly, reconnect the Media Button Cable Item 10 to the Service
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
Installation of the Service Station Assembly 1. Release any cable clamps that may be wrapped around the service station to protect it while in transportation. Note: On the service station assembly there are two locating pins, these will help you to align the service station assembly to the right hand side chassis. Note: Be careful not to damage the service station flag while performing the following procedure. 2. Install the service station assembly onto the three loosened T-20 screws (item 4). Tighten the screws. 3. Install the T-20 screw (item 3) securing the service station. Note: Make sure the tubes (item 8) are not bent or twisted. 4. Install the black service station interconnect cable (item 1) to the service station interconnect PCA, this is located under the service station assembly. Note for HP DesignJets 3500CP/3000CP: Make sure you reconnect the Media Button Cable (Item 10) to the Service Station Interconnect PCA. 5. Install the following: 1. Right Hand Cover ' page 8-21. 2. Window and Top Cover ' page 8-15. 6. Install the power cable and turn the printer on in service mode. 7. Enter service test and perform D05 service station test ' page 4-16 8. Install the ink delivery system (Refer to the User Guide). Installation of the Service Station Flag 1. Position the flag (item 7) horizontally, then push up into a retaining clip on the service station assembly. The correct clip on the flag is shown as (item 9). 2. Install the spring (item 6) from the service station flag to the service station assembly. Removal and Installation HP DesignJet CP Series Printers 8-27