HP Designjet 2800/3800cp Service Manual - Page 128
C01. Carriage, This Calibration Must Be Done With The Printheads, Installed., Enter, Previous
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
C01. Carriage The purpose of this calibration is to calibrate the temperature from which the printhead has to be warmed. THIS CALIBRATION MUST BE DONE WITH THE PRINTHEADS INSTALLED. Perform the Carriage calibration whenever the: D Carriage is disassembled or replaced. D Electronics Module is replaced. Perform the Carriage Calibration as follows: 1 In the Calibrations submenu, scroll to "C1 Carriage" and press Enter. Calibrations C1 Carriage 2 The message "Remove Printheads / Press Enter" will be displayed on the front-panel. Remove the Printheads and press Enter when you have removed them. 3 While the Calibration is being performed, a row of "***" will be displayed on the front-panel. 4 If the calibration is performed correctly, the "C0100 OK" message is displayed on the front-panel. 5 Press Previous and the "Reinstall Printheads" message is displayed on the front-panel. Reinstall the Printheads into the correct stalls in the carriage. 6 If the calibration fails, one of the following messages will be displayed on the front-panel: D "C0101 Fail" - The Cyan Printhead has failed. D "C0102 Fail" - The Magenta Printhead has failed. D "C0103 Fail" - The Cyan and Magenta Printheads have failed. D "C0104 Fail" - The Yellow Printhead has failed. D "C0105 Fail" - The Cyan and Yellow Printheads have failed. D "C0106 Fail" - The Magenta and Yellow Printheads have failed D "C0107 Fail" - The Cyan, Magenta and Yellow Printheads have failed D "C0108 Fail" - The Black Printhead has failed. The calibration is continued on the next page. Service Calibrations HP DesignJet CP Series Printers 5-7