HP Designjet 2800/3800cp Service Manual - Page 75

Message Lift lever after aligning Lift lever to continue Load arrow edge print side down Load cancelled Remove media Load error Remove media Load media for calibration Load media to align printheads Load media to check printheads Load sheet for calibration Lower lever Lower lever Remove media Lower window to continue Media too small Explanation and Action You have lowered the media lever to align the media with the entry platen. Lift the lever at the right edge of the paper path on the printer when you've finished aligning the roll media as instructed. The media lever was lowered while the processor was busy. Lift the lever at the right edge of the paper path on the printer. Remove the accuracy calibration print, turn it so that the edge with the arrows printed on it is print-side down, then load that edge into the printer. The Cancel key was pressed while media loading was in progress. Remove media. Media was inserted with the media lever raised. Lower the lever and reload the media. Load media to proceed with calibration. Load media to proceed with printhead alignment. The printer is telling you to load media so it can perform the printhead check. Load media to proceed with printhead check. The printer is ready to perform the accuracy calibration procedure, but media is not present. Load media to continue. Lower the lever at the right of the printer. Lower the lever at the right of the printer and remove the media. The window was opened while the printer was busy. Close the window to continue. You may have sent a print file that is too large for the media loaded; the print may be clipped. Press Cancel if the media is unsuitable, and reload with appropriate media. User Messages HP DesignJet CP Series Printers 3-7