HP Designjet 2800/3800cp Service Manual - Page 257

Trailing Cable Refer to figure 12 ' page 8-38 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Electronics Module ' page 8-6. 2. Window and Top Cover ' page 8-15 3. Right Hand Cover ' page 8-21 2. Manually slide the carriage assembly to the center of the printer. 3. Carefully disconnect the trailing cable (item 1) from connectors on the carriage PCA. 4. Remove the trailing cable from the trailing cable carriage clamp (item 2). 5. Remove the trailing cable from the trailing cable holder (item 3). 6. Pull the trailing cable through a hole in the Y-axis assembly (item 4). 7. Pull the trailing cable through a hole in the electronics support frame (item 5). 8. Remove the trailing cable from the 3 cable clamps at the rear of the printer (item 6). 9. Disconnect the trailing cable from the following positions in the electronics module: 1. J3 MISC 2. J5 DATA 3. J10 SUPPLY 10.Remove the trailing cable by pulling it through the ferrite (item 7) at the rear of the printer. 8-36 HP DesignJet CP Series Printers Removal and Installation