HP Designjet 2800/3800cp Service Manual - Page 82

Message Explanation and Action Roll empty Load new roll You have used all of the media roll. Load a new roll of media. Roll misaligned Reload roll Roll media is skewed. Reload media. Set transport→ Yes Mode→ Νο You have selected transport mode in the front-panel menu. The printer is waiting for you to accept or reject the transport mode. Accepting transport mode starts the process of removing all ink systems. Press ↑ to accept or press ↓ to reject. Sheet load→ Roll load→ Press ↑ to load sheet media. Press ↓ to load roll media. Sheet misaligned Reload sheet Sheet media is skewed. Remove it and reload it so that the left and right edges being loaded into the printer are square. The leading edge must also be straight. Sheet required for calibration You have started an accuracy calibration check but media is not present. Load media. Sheet / Roll? Reload media Switch power off Switch power off Check paper path Switch power off Check printhead path System Error 060000 Either: Sheet mode was chosen while loading roll media. Reload media. Or: a sheet more than 51 inches (130 cm) long was loaded. Trim the sheet and reload. You have selected the transport mode shut-down sequence. The printer is waiting for you to turn the power switch, on the rear of the printer, to OFF. Switch OFF the printer. The printer may be jammed with media. Turn OFF the printer. Check the media path and clear it if necessary. Then turn on the printer. The printhead carriage cannot move. The printer may be jammed with media. Turn OFF the printer. Check the media path and clear it if necessary. Then turn ON the printer. The ambient light level in the area of your printer is too bright and is causing the optical sensor in your printer to malfunction. Reduce the ambient light level or move the printer to a location where the light level is lower. 3-14 HP DesignJet CP Series Printers User Messages