HP Designjet 2800/3800cp Service Manual - Page 85

Message Explanation and Action STATUS Lens maintenance STATUS Loading roll The lens cover on the printhead carriage requires maintenance. Press the Replace Ink System key to replace the lens cover with a new one. Spare lens covers are inside the right door. The printer is loading roll media. Wait for the loading to complete. STATUS Loading sheet The printer is loading sheet media. Wait for the loading to complete. STATUS Low on ink One or more of the four ink systems are out of ink. Press the Replace Ink System key to replace the ink systems affected, if the last print showed any degradation in image quality. If there is still a large amount of ink remaining in the ink cartridges, see the message Printhead failure. STATUS The printer is being used more intensively than the recommended duty cycle. Maintenance advised Refer to Chapter 9 to perform the Preventive Maintenance. STATUS Measuring pattern The printer is measuring the accuracy calibration print that you just loaded. Wait for the calibration to complete. STATUS Out of media STATUS Pause pending STATUS Paused STATUS Printing The printer has received a file, is ready to print, but has no media loaded. Load appropriate media. You have pressed the Pause key but the printer was busy performing a previous action. The printer will pause when it has completed its current action. Wait for the current action to complete. You have pressed the Pause key. The printer will remain paused until you press the Pause key again. Press the Pause key again when you are ready. The printer is printing. Wait for the printing to complete. STATUS Printing (Special) STATUS Processing The printer is printing with a special print mode controlled by your software rather than by the printer. Wait for the printing to complete. The printer has received a file from your software and is processing it ready to print. Wait for the printing to complete. User Messages HP DesignJet CP Series Printers 3-17