HP Designjet 2800/3800cp Service Manual - Page 285
Refill Interconnect PCA
View all HP Designjet 2800/3800cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 285 highlights
Refill Interconnect PCA Refer to figure 23 ' page 8-65 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Left Hand Cover assembly ' page 8-18. 2. Remove the top half of the elevator assembly by releasing it from two retaining clips at the back and lifting up and to the left. 3. Carefully disconnect all cables (item 4) from the refill interconnect PCA. 4. Remove the refill interconnect PCA (item 1) by removing two T-20 screws (item 2) installed through two support rings (item 3) and into the left hand side chassis. Installation 1. Install two T-20 screws (item 2) through the refill interconnect PCA and the two supporting rings (item 3) into the left hand side chassis. 2. Connect all cables (item4) to the refill interconnect PCA. 3. Install the top half of the elevator assembly by securing it to two retaining clips at the back and push down and to the right. 4. Install the following: 1. Left Hand Cover assembly ' page 8-18. 5. Connect the power cord. 6. Perform the following service tests: 1. D11 Bail ' page 4-7. 2. D08 Sensors ' page 4-20. 3. D03 Carriage Axis (Y-axis) ' page 4-12 . 4. D06 Refill ' page 4-18. 8-64 HP DesignJet CP Series Printers Removal and Installation