HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 145

Chapter 7 MtcEthP and MtcEtx Messages IOPn.MtcEtx status: Registry parameter mismatch between IOPs. Using default value. Severity Warning Description MtcEtx includes the current parameter values in the Control PDUs used to establish a virtual circuit. This message is logged if the parameters on the IOPs do not agree. The Event Log Data section contains the invalid parameter value. MtcEtx will use the default value for the parameter. Another possible cause for this error is a change in the default parameter values between MtcEtx versions. This message is also logged if one IOP is upgraded to a new version of the HP NetServer AA software and rebooted without simultaneously upgrading and rebooting the other IOP. Action • Run a Registry editor and note the values under HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\MtcEtx \Parameters. • Contact your service provider for further assistance. See Also The HP NetServer AA Manager command IOPn.IopLinkDriver Show Parameter Values. IOPn.MtcEtx status: Send buffer descriptor allocation failure. Severity Error Description MtcEtx was unable to allocate an NDIS_BUFFER resource needed to transmit an Ethernet packet. This can be a fatal error, and results in the IOP being shut down. Action Contact your service provider for assistance. IOPn.MtcEtx status: Send packet allocation failure. Severity Error Description MtcEtx was unable to allocate an NDIS_PACKET resource needed to transmit an Ethernet packet. This can be a fatal error, and results in the IOP being shut down. Action Contact your service provider for assistance. 135