HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 305
Table 14-1, MtcScsiP and MtcScsiR Status Message Summary, Continued,
![]() |
View all HP NetServer AA 6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 305 highlights
Chapter 14 MtcScsiP and MtcScsiR Messages Table 14-1 MtcScsiP and MtcScsiR Status Message Summary (Continued) Message Page IOPn.MtcScsiP status: Cannot obtain SCSI mode page data for DISKn. This is typical for RAID controllers. IOPn.MtcScsiP status: Cannot obtain SCSI read-write recovery mode page data for DISKn. This is typical for RAID controllers. IOPn.MtcScsiP status: CDROMn may not be SCSI-2 (or newer SCSI standard) compliant. IOPn.MtcScsiP status: Command not valid for non-mirrored disks. IOPn.MtcScsiP status: Command to DISKn not valid because it is a non-mirrored disk. HP NetServer AA Manager request to non-mirrored disk was ignored. IOPn.MtcScsiP status: Configured ADAPTERn failed to reset bus BUSx. Disks connected to this adapter may be marked faulted. IOPn.MtcScsiP status: Configured ADAPTERx has a misconfigured bus ID BUSn. Use the HP NetServer AA Configuration Utility to change the bus ID. IOPn.MtcScsiP status: Configured ADAPTERx has different initiator IDs for bus BUSn. Use the BIOS setup program available via your SCSI adapter to reconfigure the initiator ID. The IOPs will not be allowed to join until this problem is resolved. IOPn.MtcScsiP status: Copy for selected disk has not failed. IOPn.MtcScsiP status: Device DISKn has failed. See prior events for reason. IOPn.MtcScsiP status: Device DISKn will be faulted because it is taking too long to complete SCSI requests. The IOP must be rebooted before the disk can be enabled. IOPn.MtcScsiP status: DEVICEn has a SCSI adapter number different than configured on the other IOP, and it will be marked offline. IOPn.MtcScsiP status: DEVICEn has a SCSI bus number different than configured on the other IOP, and it will be marked offline. IOPn.MtcScsiP status: DEVICEn has a SCSI logical unit number (LUN) different than configured on the other IOP, and it will be marked offline. IOPn.MtcScsiP status: DEVICEn has a target ID different than configured on the other IOP, and it will be marked offline. IOPn.MtcScsiP status: DEVICEn location contains an unsupported device. IOPn.MtcScsiP status: DEVICEn location does not contain the expected device type. IOPn.MtcScsiP status: DEVICEn powered up successfully. IOPn.MtcScsiP status: DEVICEn was not found, and it will be marked offline. page 307 page 307 page 308 page 308 page 309 page 309 page 309 page 310 page 310 page 310 page 311 page 311 page 311 page 312 page 312 page 312 page 313 page 313 page 313 295
![](/manual_guide/products/hewlettpackard-netserver-aa-4000-hp-netserver-aa-6200-solution-release-30-messages-13dd408/305.png)