HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 94

Chapter 4 MtcCEX Messages MtcCEX: Unable to generate SYSERR packet. Status = 0xy Variables y - an error status displayed in hexadecimal Severity Error Description This message displays in a Windows NT blue screen on a monitor attached directly to a CE when the HP NetServer AA CE Transport experiences an unexpected failure while preparing to generate a system error. This error is fatal to CE operations and is followed by a reset of the CE. Hardware/Software This message most likely indicates a hardware failure in the CE that displays the message. Action The CE will be reset and will be resynchronized into the system unless the number of failures exceeds a threshold. If the threshold is exceeded, the CE is marked faulted and is not resynchronized. In this case, the CE is diagnosed offline. After you repair or replace the CE, manually return it to service. MtcCEX: Unable to initialize QI mechanism. Status = 0xy Variables y - an error status displayed in hexadecimal Severity Error Description This message displays in a Windows NT blue screen on a monitor attached directly to a CE during CE operating system boot when the HP NetServer AA CE Transport experiences an unexpected failure while attempting to perform MtcCEX driver initialization. This error is fatal to CE operations and is followed by a reset of the CE. Hardware/Software This message indicates a software failure while attempting to map the P6 APIC. Action The CE is reset, and a reboot may be attempted. If this failure recurs repeatedly, the CE will be marked faulted. • If this failure recurs, verify that the CE's system memory meets the HP NetServer AA size requirements, and increase it if necessary. • If the problem persists, contact your service provider for assistance. 84