HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 321

Chapter 14 MtcScsiP and MtcScsiR Messages IOPn.MtcScsiP status: Device DISKn will be faulted because it is taking too long to complete SCSI requests. The IOP must be rebooted before the disk can be enabled. Variables n - the disk number; for example, DISK0, DISK1, DISK2 Severity Error Description A disk has not completed pending SCSI requests in an appropriate time period. This typically occurs as a disk begins to fail. However, it is also possible that incorrect SCSI termination settings or bad SCSI cabling are to blame. Action • Reboot the IOP and check the SCSI termination settings, the SCSI cable integrity, and the SCSI cable connections. • If these items all appear to be correct, consider replacing the disk. IOPn.MtcScsiP status: DEVICEn has a SCSI adapter number different than configured on the other IOP, and it will be marked offline. Variables n - the device number; for example, DISKn, CDROMn, TAPEn Severity Error Description A configured SCSI adapter for the device on the local IOP does not match the configured adapter number for the device on the remote IOP. Action Use the HP NetServer AA Configuration Utility to fix the configuration files on each IOP so that this device has the same SCSI adapter number on each IOP. IOPn.MtcScsiP status: DEVICEn has a SCSI bus number different than configured on the other IOP, and it will be marked offline. Variables n - the device number; for example, DISKn, CDROMn, TAPEn Severity Error Description A configured SCSI bus number for the device on the local IOP does not match the configured SCSI bus number for the device on the remote IOP. Action Use the HP NetServer AA Configuration Utility to fix the configuration files on each IOP so that this device has the same SCSI bus number on each IOP. 311