HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 236

Chapter 13 MtcMon Messages IOPn.MtcMon status: An Endurance Manager request to shut down the operating system on the CE(s) could not be performed because the Endurance System Management Service on the CE(s) is not active. Severity Warning Description This message is generated after issuing a command to shut down the CE's Windows NT operating system. To perform this operation, the Endurance System Management Service must be active on the CEs. The Endurance System Management Service on the CE(s) has not yet started. The Endurance Manager request is not completed. Related Messages IOPn.MtcMon status: An Endurance Manager command has been issued to shut down Tuplex. IOPn.MtcMon status: An Endurance Manager command has been issued to disable Tuplex. IOPn.MtcMon status: Server shutdown has been requested by the operator. IOPn.MtcMon status: CE operating system shutdown has been requested by the operator. Hardware/Software This message is generated by software in response to a user's request to shut down the Windows NT operating system on the CE(s). Action Examine the services running on the CE(s): • Make sure that the CEs are operational and are running Windows NT. • Make sure that Endurance Manager is running on the CE(s). IOPn.MtcMon status: An error occurred activating Interconnect ESIx. Variables x - the ID of the ESI that had an error during activation Severity Error Description During IOP joining, the ESI between the joining IOP and the CE experienced an error. This message results in the joining process being aborted. The Interconnect is thresholded. If the threshold is not exceeded, the IOP retries joining. If the threshold is exceeded, the Interconnect is faulted, and the IOP remains idle until you issue an ESI Enable command. Related Messages IOPn.MtcMon status: The join process has failed for IOPx. IOPn.MtcMon status: ESIx is faulted and requires repair. Hardware/Software This message is usually due to a hardware problem with the specified Interconnect. Action • If the IOP joining process succeeds on retry, no action is required. However, the Interconnect has experienced at least a transient error that may be intermittent. • If the Interconnect error threshold is exceeded, the Interconnect is faulted. Repair the Interconnect and issue an ESI Enable Operation command. The IOP remains idle until you issue the command; then the IOP automatically rejoins the Endurance server. 226