HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 306
MtcScsiP and MtcScsiR Messages
![]() |
View all HP NetServer AA 6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 306 highlights
Chapter 14 MtcScsiP and MtcScsiR Messages Table 14-1 MtcScsiP and MtcScsiR Status Message Summary (Continued) Message Page IOPn.MtcScsiP status: Disk could not be enabled. page 313 IOPn.MtcScsiP status: Disk is a mirror copy target. Status is offline pending copy start. page 314 IOPn.MtcScsiP status: Disk is already disabled. page 314 IOPn.MtcScsiP status: Disk is already online. page 314 IOPn.MtcScsiP status: Disk must be offline. page 314 IOPn.MtcScsiP status: DISKn cannot be accessed for initialization, and it will be marked offline. page 315 IOPn.MtcScsiP status: DISKn cannot be physically accessed. See prior events for reason. page 315 IOPn.MtcScsiP status: DISKn contains an invalid partition table. The disk must be repartitioned. page 315 IOPn.MtcScsiP status: DISKn contains too few partitions. Use Disk Administrator in Offline HP NetServer AA I/O Processor Mode to partition the disk, making sure to add an HP NetServer AA partition. page 316 IOPn.MtcScsiP status: DISKn copy target on IOPx has been newly installed, but copy source on IOPy page 316 has not. Install CE and IOP software on copy source (IOPy). IOPn.MtcScsiP status: DISKn could not be enabled. Check prior events for reason. page 316 IOPn.MtcScsiP status: DISKn did not come ready, and it will be marked offline. page 317 IOPn.MtcScsiP status: DISKn did not power up properly, and it will be marked offline. page 317 IOPn.MtcScsiP status: DISKn does not have a bootable partition. Use Disk Administrator in Offline HP NetServer AA I/O Processor Mode to mark the desired boot partition as active. The disk will be kept offline until it contains a partition marked as bootable. page 318 IOPn.MtcScsiP status: DISKn does not support automatic bad block remapping for recoverable read requests. page 318 IOPn.MtcScsiP status: DISKn does not support automatic bad block remapping for write requests. page 318 IOPn.MtcScsiP status: DISKn encountered a bad block at SECTOR during a mirror copy. page 319 IOPn.MtcScsiP status: DISKn encountered a write error during a mirror copy. page 319 IOPn.MtcScsiP status: DISKn failed a SCSI request, and repeated retries did not succeed. The disk will be marked faulted. page 320 IOPn.MtcScsiP status: DISKn had a previous failure. The device must be manually enabled, using the page 320 HP NetServer AA Manager, before it can be used. 296
![](/manual_guide/products/hewlettpackard-netserver-aa-4000-hp-netserver-aa-6200-solution-release-30-messages-13dd408/306.png)