HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 335

Chapter 14 MtcScsiP and MtcScsiR Messages IOPn.MtcScsiP status: DISKn has an invalid partition signature. Use Disk Administrator in Offline HP NetServer AA I/O Processor Mode to partition the disk, making sure to add an HP NetServer AA partition. Variables n - the disk number; for example, DISK0, DISK1, DISK2 Severity Error Description The disk does not have a valid partition table. It must be partitioned and formatted. Action Repartition the disk. See Chapter 9 in HP NetServer AA Solution Administrator's Guide for details about repartitioning a mirrored disk. IOPn.MtcScsiP status: DISKn has an IOP ID other than the current IOP ID. This indicates DISKn has come from a different IOP. The HP NetServer AA partition can be reset to cure this condition, but caution is advised. If unsure how to proceed, contact your service provider for assistance. Variables n - the disk number; for example, DISK0, DISK1, DISK2 Severity Error Description A disk that belongs to another IOP has been moved to the local IOP. The disk must have its HP NetServer AA partition reset if it is to be used in the local HP NetServer AA system. However, if the disk's HP NetServer AA partition is reset, it is very likely that it will become a mirror copy target, causing any stored data on the disk to be overwritten. Additionally, there are scenarios in which the disk could become a mirror copy source, causing any stored data on the other existing mirror set member to be overwritten. See the action section for details. Action This condition should only occur if a replacement disk has been taken from elsewhere and used to replace a faulted disk. • In this case, assuming the CEs are up and running, you can reset the disk's HP NetServer AA partition, and it will become a mirror copy target. • However, if this scenario is not desirable, or the CEs are not up and running, contact your service provider before continuing. 325