HP NetServer AA 6200 HP NetServer AA 6200 Solution Release 3.0 Messages - Page 184

Chapter 12 MtcMICX Messages (Continued) Code OF 10 12 13 Description Action IOP ID improperly configured. The IOP ID programmed into the MIC adapter by the MIC BIOS setup program does not match the IOP ID programmed into the HP NetServer AA software. MtcMICX is not loaded, and the IOP cannot join the HP NetServer AA configuration. The first additional data item specifies the IOP ID programmed into the MIC adapter. The second additional data item specifies the IOP ID programmed into the HP NetServer AA software. • Reboot the IOP and enter the BIOS setup program. • Modify the IOP ID so that it matches the IOP ID that was specified when the HP NetServer AA software was installed on this IOP. • Optionally, reinstall the HP NetServer AA software on this IOP to match the ID programmed in the MIC adapter by the BIOS setup program. MIC is in loopback mode The MIC adapter is in loopback mode. MtcMICX will not register with the HP NetServer AA Monitor until the MIC is removed from loopback mode. Remove the loopback connector from the MIC module and attach the fiber cables to the MIC module. Cannot create device Could not create an object for the MIC adapter with IoCreateDevice. The status code returned by the IoCreateDevice system service is also logged as additional data. Contact your service provider if you encounter this message. Cannot read Registry MtcMICX could not read its startup parameters from the Windows NT Registry. Note: The status code returned by the Windows NT system service is also logged as additional data. • Reinstall the HP NetServer AA software on the IOP. This should recreate the Windows NT Registry information for MtcMICX. • If this does not resolve the problem, contact your service provider for assistance. 174