Ricoh 3035 General Settings Guide - Page 163

7. Remarks Dos and Don'ts R CAUTION: • Unplug the power cord from the wall outlet before you move the machine. While moving the machine, you should take care that the power cord will not be damaged under the machine. Important ❒ Do not turn the power off while the On indicator is lit or blinking. Doing so may damage the hard disk. ❒ Before unplugging the power cord or turning off the main power switch, make sure remaining memory space is at 100%, as shown on the display. See p.28 "Turning Off the Power" and "Turning Off the Main Power". • When you use this machine for a long time in a confined space without good ventilation, you may detect an odd smell. To keep the workplace comfortable, we recommend that you keep it well ventilated. • Do not touch areas on or around the fusing unit. These areas get hot. • After scanning originals continuously, the exposure glass may become warm-this is not a malfunction. • The area around the ventilation hole might feel warm. This is caused by exhaust air and is not a malfunction. • When the machine is not in use and in stand-by mode, you may hear a small noise inside. This is caused by the image stabilization process and is not a malfunction. • Do not turn off the power when the machine is still in operation. • The machine might not produce good images if condensation forms inside as a result of rapid temperature change. • Do not open the covers of the machine when it is in operation. If you do, misfeeds might occur. • Do not move the machine when the power is on. • If you operate the machine improperly or a machine failure occurs, settings might be lost. Be sure to make a note of your machine settings. • The manufacturer shall not be liable for any loss or damage resulting from mechanical failure, loss of settings, or use of the machine. 151