Ricoh 3035 General Settings Guide - Page 168
Maintaining Your Machine
View all Ricoh 3035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
Remarks Maintaining Your Machine If the exposure glass or ADF belt is dirty, copy clarity may be reduced. Clean these parts if they are dirty. ❖ Cleaning the machine Wipe the machine with a soft, damp cloth, and then wipe it with a dry cloth to remove the water. Cleaning the Auto Document Feeder Important ❒ Do not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances get inside the machine or melt plastic parts, a failure might occur. ❒ Do not clean parts other than those GDSH130J explicitly specified in this manual. Other parts should only be cleaned Clean 1 and 2. by your service representative. Changing the Photoconductor 7 Cleaning the Exposure Glass Unit (PCU) Only use the photoconductor unit made specifically for this machine. Follow the procedure below to change the unit. Clean 1 and 2. Important ❒ Be sure to unplug the power code from the outlet before changing the photoconductor unit. A Open the front door, duplex unit, and then transfer unit right cover. GDSH050J B Push the development unit to the left, and then pull out the photocon- ductor unit. C Remove the harness clamps on the charge unit and cleaning unit of the new photoconductor unit. D Push the development unit to the left, and then install the new photoconductor unit. 156