HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 101

cfgEnable 2 cfgEnable Enables a zone configuration. Synopsis cfgenable "cfgName" Description Use this command to enable a zone configuration. The specified zone configuration is built by checking for undefined zone names, zone alias names, or other inconsistencies by expanding zone aliases, removing duplicate entries, and then installing the effective configuration. If the build fails, the previous state is preserved (zoning remains disabled, or the previous effective configuration remains in effect). If the build succeeds, the new configuration replaces the previous configuration. Refer to the cfgShow command for a description of defined and effective configurations. This command requires a Brocade Advanced Zoning license. When security is enabled, this command can be issued only from the primary FCS switch. Operands This command has the following operand: "cfgName" Specify the name of a zone configuration to enable, in quotation marks. This operand is required. Examples To enable the zone configuration "USA_cfg": switch:admin> cfgenable "USA_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. Do you want to enable 'USA_cfg' configuration (yes, y, no, n): [no] y zone config "USA_cfg" is in effect Updating flash ... See Also cfgClear, cfgDisable, cfgSave, cfgShow Fabric OS Command Reference Manual 69 53-1000436-01