HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 137

configure 2 Always send RSCN?Following the completion of loop initialization, a remote state change notification (RSCN) is issued when FL_Ports detect the presence of new devices or the absence of preexisting devices. When set to 1, an RSCN is issued upon completion of loop initialization, regardless of the presence or absence of new or pre-existing devices. System Services Settings The System Services Settings are shown in the table. TABLE 7 Configure Command System Services Parameters Field Default Range rstatd Off rusersd Off telnetd On On/Off On/Off On/Off Descriptions of the system service settings are as follows: rstatd Dynamically enables or disables a server that returns information via remote procedure calls (RPC) about system operation information. The protocol provides for a wide-range of system statistics; however, only the Ethernet interface statistics (see ifShow ) and system up time(see upTime) are supported. The retrieval of this information is supported by a number of operating systems that support RPC. Most UNIX-based systems (HP-UX, Irix, Linux, Solaris, and so on.) use the RUP and RSYSINFO commands to retrieve the information. Refer to your local system documentation for the appropriate usage of the these or equivalent commands. rusersd Dynamically enables or disables a server that returns information about the user logged into the system through remote procedure calls (RPC). The information returned includes user login name, system name, login protocol or type, login time, idle time, and remote login location (if applicable). The retrieval of this information is supported by a number of operating systems that support RPC. On most UNIX-based systems (HP-UX, Irix, Linux, Solaris, and so on.) the command to retrieve the information is rusers. Refer to your local system documentation for the appropriate usage of this or an equivalent command. telnetd Used to enable or disable the telnet interface to a switch, including sectelnet. If you are using SSH to manage a switch, you can disable the telnet interface for greater security. The default value is on (telnet enabled). Portlog Events Enable/Disable Settings Port events can be disabled from logging. The default is enabled (on). When disabled, this event is not logged by the port log. Fabric OS Command Reference Manual 105 53-1000436-01