HP StorageWorks 2/16V Brocade Fabric OS Command Reference Manual - Supporting - Page 630

2 secTempPasswdSet secTempPasswdSet Sets a temporary password on a remote switch. Synopsis sectemppasswdset domain, "login_name" Description Use this command to set a unique temporary password for a given account on a specific switch in the fabric. Use the secTempPasswdReset command to remove the temporary password or reboot the switch. You can change any password on any switch. To change the password of an account that has higher level than that of the current user logged in to the primary FCS switch, you must enter the password of the same level account on the primary FCS switch. The password setup on the target is not persistent and will be reset to the secure fabric-wide setting when this target switch is rebooted or when secTempPasswdReset is run on primary FCS switch. Each switch has four accounts: root, factory, admin, and user. Root and factory accounts are disabled for non-FCS switches. This command can enable the root or factory account on a non-FCS switch when you specify a password for those accounts. The password should between 8 and 40 characters. This command can be issued only when secure mode is enabled, and only from the primary FCS switch. Operands This command has the following operands: domain Specify the domain of a switch for which you want to change the password. This operand is required. "login_name" Specify the login name for which you want to change the password. This operand is required. Examples To set the password on a remote switch with a domain of 2: primary-switch:admin> sectemppasswdset 2, "root" Changing password for root Set remote switch root password: Re-type new password: Login sessions with password changed will be terminated. Password successfully set on domain 2 for root See Also passwd, secModeDisable, secModeEnable, secModeShow, secNonFCSPasswd, secTempPasswdReset 598 Fabric OS Command Reference Manual 53-1000436-01